Off the map - a typewriter table

A few weeks ago I shared a lot of awesome map inspiration from Pinterest.  Now I am back with my own awesome map project.  (Awesome in my opinion anyway).  It all started with this little typewriter table I picked up at a yard sale for four bucks. 

I knew right away that this was going to be my next map project.  I started off with a little primer and white spray paint.  Then I picked a few maps from my map collection.  I wanted the maps to fit inside each of the three sections on top.  I carefully cut out my map pieces and mod-podged them to the tray. 

At this point it looked pretty awesome from a distance but up close it was a bit of a wrinkled mess.  Plus, I knew I wanted the top to be a bit more durable than simply mod-podged paper.  I decided resin would be the perfect solution.  I had never used resin before so after doing some research I picked up some Envirotex pour-on resin at Michael's.  This was the perfect choice.  My table now has a durable, glossy finish and not a wrinkle in sight.

I've heard resin can be very finicky so I followed the directions for mixing the two parts to a T. 
A few tips for using this resin:

• If you are using resin on top of paper, be sure to seal the paper surface first with a few layers of mod-podge or a similar sealer.  Pay special attention to making sure the edges are completely sealed to the surface.  If there are any bubbles or cracks, the resin will leak under the paper and cause discoloration.
• When you pour the resin onto your project, tiny bubbles will appear everywhere.  The directions say to use a propane torch to easily remove the bubbles.  I don't have a propane torch and I wasn't about to buy one.  It does say that you can exhale gently to get the same results.  I read a tip online to blow slowly through a straw which is what I did and it worked perfectly.  DO NOT use a blowdryer. That will not help.  It is not the heat that removes the bubbles, it is the carbon dioxide.  
• If you do use the blow-through-a-straw method, be careful that no tiny drips of spit make it onto the resin.  (Just being real here).  Water droplets will cause bubbles that cannot be blown out.  (This happened to me and I used a foam brush to gently remove the contaminated resin while it was still wet).
• Make sure to mix enough resin for your project.  You don't want to run out.  But also, pour very slowly so that you don't pour on too much.  I overpoured one of the sections and it was a huge pain dealing with the overflow. 
• It really isn't that hard to do a project like this.  The resin is self-leveling so basically you just mix it and pour it on and it takes care of the rest. 

I am so happy with how this project turned out.  It was supposed to be for sale in my booth, but I just might keep it.  This typewriter table  happens to also make the perfect laptop table.

If you love map projects as much as me, be sure to hop over and check out my map mirror too.